Drying Conditions
Temperature
80°C
Time
4-6h
Target Moisture
0.08%
A dehumidifying dryer is recommended (relatively hygroscopic).
Melt Temperature
270~310°C
Mold Temperature
80~120°C
Shrinkage
1.5~2.5%
Common Defects & First Checks
Sink Mark
PA410(bio-based): castor oil-derived, ~30% lower moisture uptake than PA66, crystallizes faster.
Warpage
PA410(bio-based): castor oil-derived, ~30% lower moisture uptake than PA66, crystallizes faster.
Field Notes
PA410(bio-based): castor oil-derived, ~30% lower moisture uptake than PA66, crystallizes faster. Mold below 80°C gives amorphous surface with poor gloss. Sink at bosses: raise mold temp + optimize gate.
Related Resins
This data is a field-reference summary. Always verify against the resin manufacturer’s official TDS.